PLANET ICA-8350 - Manual (Page 52)

3Mega-Pixel Vandal Proof Fish-Eye IP Camera
ICA-8350
52
Exposure Value Exposure value is AE target value. This value is to adjust the
integration, analog gain and digital gain to achieve the target
brightness value (Exposure Value).
This value is dependent to “Auto Exposure” only
Color Level Large value will be colorful.
Hue Change the value will result to color tuning.
Brightness Large value will brighten camera.
Contrast Large value will contrast camera heavily.
Sharpness Large value will sharpen camera.
Local video output Enable or disable video signal of BNC connector. It’s very useful
to check view angle or focus during camera installation. However,
disable this function will save power a lot. Suggest to disabling it
after camera installed well.
ICR Use built-in photo sensor or manual to control ICR.
In case user selects manual mode, there are 4 modes: Night
(On), Day (Off), Auto or Schedule to control built-in IR LEDs. This
function is very useful under low illumination environment even 0
Lux.
In case the Auto mode is selected, user needs to specify 3
parameters in advance:
Night Mode Threshold (0~10000): this value set the threshold to
turn on IR LED. It should be lower or equal to Day Mode
Threshold.
Day Mode Threshold (0~10000): this value set the threshold to
turn off IR LED. It should be higher or equal to Night Mode
Threshold.
Delay Time: The delay time between LED ON/OFF switching.
Note: that Current Value is the current luminance from the
captured video. It’s a useful reference to set LED ON/OFF
Threshold.
3D De-Noise This function can remove or lower unwanted noise and preserve
fine details and edges as possible.