PLANET ICA-8350 - Manual (Page 17)

3Mega-Pixel Vandal Proof Fish-Eye IP Camera
ICA-8350
17
2. Terminal block:
Pin definition:
Pin Name Function
1 12VDC in DC 12V power input
2 MIC in- External MIC input-
3 MIC in+ External MIC input+
4 Audio out+
5 Audio out-
6 Video out Composited video output
7 12VDC out DC 12V output (50mA maximum)
8 DI Digital signal input
9 GND Digital ground
10 DO Digital signal output
11 RS485+ RS485 data +
12 RS485- RS485 data -
12VDC in & Power GND
The input power is 12VDC. Note that supply the power to the Network Camera with
the power adapter included in package.
MIC in (audio in)
Connect an external microphone to the camera.
Audio out +/-
Connect a loud speaker to the camera. This function is for voice alerting and
two-way audio.
Video out
Connect a TV monitor to the camera. User can check the focus/zoom and view
angle of the camera.
12VDC out
The output power is 12VDC. This is used to support DI/DO devices. The output
power is 12VDC/50mA maximum.
DI/GND/DO/RS485
Interface of Digital input/output and RS485
3. Factory Default Reset
This button is used to restore the all factory default settings. Sometimes restarting
the device will make the system back to a normal state. However, if the system still
got problems after restart, user can restore the factory default settings and configure
it again.
Restore the device:
(i) Press the button down continuously.
(ii) Hold the button at least 5 seconds and release it. Then the device has