PLANET WGSW-28040 - Manual (Page 13)

13
Save Configuration
In switch, the running configuration file stores in the RAM. In the current version,
the running configuration sequence running-config can be saved from the RAM to
FLASH by write command or copy running-config startup-config command, so
that the running configuration sequence becomes the start up configuration file,
which is called configuration save.
To save all applied changes and set the current configuration as startup
configuration. The startup-configuration file will be load automatically across a
system reboot.
1. Click Maintenance, Save Configuration.
2. Select “startup-config.cfg” as the drop-menu, and then click “Save Configuration”
button.
Figure7-5: Save Configuration screen
 While IP Address be changed or forgotten admin password –
To reset the IP address to the default IP Address “192.168.0.100” or reset the login
password to default value. Press the hardware reset button at the front panel
about 10 seconds. After the device is rebooted, you can login the management
WEB interface within the same subnet of 192.168.0.xx.
Reset