Emerson Liebert Power Solutions - Manual (Page 37)

37
Liebert Type SS—Approved by Motorola
R56 Committee, Standards and Guidelines
for Communication Sites—Type 1 and 2
Devices. Utilizes advanced SAD/MOV array
technology for industry leading transient
suppression voltages. Up to 160 kA surge
current capacity for increased reliability.
Liebert PanelGuard Extension—An add-on
device for integration with panelboards at
the jobsite for enhanced surge suppression.
Surge current capacity levels range from
130 kA to 200 kA per phase.
Liebert PowerSure Panel—Surge
suppression systems protect connected
equipment against electric power line
disturbances and transients in medium and
low exposure locations. Displays LED
indication per phase. Provides remote
indication capabilities. Alerts with
audible alarm.
Islatrol ® SP-6TVN Series—The Islatrol SP-
6TVN is a surge suppressor/filtering
device that features uniquely designed
repositionable outlets and protects sensitive
home/office equipment including home
theaters, satellite dishes, computers,
printers and faxes.
Islatrol ® Rackmount Series—This line of AC
surge protectors is ideal for protecting the
power feeding valuable rack equipment.
This series provides 40,000 Amps of surge
protection and up to 60 dB of high-
frequency noise filtering.
Edco Rackmount Series—Includes 16 and
48-channel high-speed data line protectors
that utilize three-stage hybrid technology.
These units address high-energy voltage
transients that can damage expensive
network equipment. Ideal for network patch
panels, switches and hubs, these units
mount easily in the same racks as the
equipment they are protecting.
Edco PC642 Series—The Edco PC642 Series
surge suppressor is a two-pair (four-wire)
module implementing three-stage hybrid
technology. This module addresses
over-voltage transients with gas tubes and
silicon avalanche components.
Edco LCDP Series—The Edco LCDP Series is
designed to conveniently protect 8 wire, low
voltage data circuits and employs two RJ-45
jacks for easy installation.
Edco RJA-RJD Series—The Edco
RJA and Edco RJD Series are four pair
telephone/data line protectors that
implement advanced two stage
hybrid design.
Edco CAT6-5 POE Series—The Edco CAT6-
POE Series is designed to work on Category
5 Power-Over-Ethernet transmission lines as
well as Category 6 applications.
Edco PHC Series—This surge suppressor is
designed to protect two pairs of wires
specifically for alarm and security systems
where operating currents can be as high as 5
Amps. It utilizes three-stage hybrid
technology to address overvoltage
transients and sneak and fault current for
signaling circuits.
Liebert manufactures the industry’s widest range of
transient voltage surge suppression (TVSS) equipment.
These products are ideal for small facilities, large
equipment rooms or entire buildings. Plus a wide range
of power, control and data line applications. Each surge
protection product features the rugged reliability that
has been Liebert’s trademark for more than 30 years.
Installing protection at the electrical service entrance,
distribution points, branch panelboards and on specific
sensitive loads or equipment throughout your facility is
the best way to prevent damage and eliminate
associated downtime to sensitive microprocessor-
based electronics.
S
UR
G
E
P
R
O
TE
C
T
IO
N AND
P
O
WER
C
O
ND
IT
IO
NI
N
G
S
Y
S
TEM
S
6