PLANET MGSW-24160F - Manual (Page 5)

5
3. Wiring DC Power Inputs
The 6-contact terminal block connector on the rear panel of MGSW-24160F is used
for two DC redundant powers input. Please follow the steps below to insert the
power wire.
1. Insert positive / negative DC power wires into the contacts 1 and 2 for DC
POWER 1, or 5 and 6 for DC POWER 2.
2. Tighten the wire-clamp screws for preventing the wires from loosing.
1 2 3 4 5 6
DC 1
Fault Alarm
DC 2
+ - + -
Note
The wire gauge for the terminal block should be in the range
between 12 ~ 24 AWG.