Avago Technologies MegaRAID SCSI 320-0X (530) - Manual (Page 22)

2-4 MegaRAID 320-0X Hardware Installation
Copyright © 2005 by LSI Logic Corporation. All rights reserved.
Figure 2.1 Inserting the MegaRAID 320-0X Card in a PCI Slot
Step 5. Set the Target IDs.
Set target identifiers (TIDs) on the SCSI devices. Each device
in a channel must have a unique TID. Provide unique TIDs for
non-disk devices (CD-ROM or tapes), regardless of the channel
they are connected to. The MegaRAID 320-0X storage adapter
automatically occupies TID 7, which is the highest priority. The
arbitration priority for a SCSI device depends on its TID.
Table 2.1 Target ID’s
Priority Highest Lowest
TID 7 6 5 . . . 2 1 0 15 14 . . . 9 8
32-bit
64-bit
Edge of
Mother Board
Bracket Screw
Slots
Slots
Note:The slot for the MegaRAID 320-0X card is a special ZCR slot on
the motherboard.