2 quick installation, 3 detailed installation, Quick installation – Avago Technologies MegaRAID SCSI 320-0X (530) User Manual
Page 20: Detailed installation

2-2
MegaRAID 320-0X Hardware Installation
Copyright © 2005 by LSI Logic Corporation. All rights reserved.
2.2
Quick Installation
The following steps are for quick storage adapter installation. These
steps are for experienced computer users/installers.
contains the steps for all others to follow.
Note:
Be sure to make a backup of all the data on your hard
drives before you install the MegaRAID 320-0X ZCR
storage adapter. Failure to do so could result in data loss.
Step 1.
Turn power off to the server and all hard drives, enclosures, and
system components and remove the PC power cord.
Step 2.
Open the cabinet of the host system by following the
instructions in the host system technical documentation.
Step 3.
Check the jumper settings on the adapter.
Step 4.
Install the MegaRAID 320-0X storage adapter in a special
PCI-X expansion slot.
Step 5.
Perform a safety check.
◊
Ensure that the MegaRAID 320-0X storage adapter is
properly installed.
◊
Close the cabinet of the host system.
Step 6.
Turn power on after completing the safety check.
2.3
Detailed Installation
This section provides detailed instructions for installing a MegaRAID
320-0X storage adapter.
Step 1.
Unpack the Adapter
Unpack and remove the storage adapter. Inspect it for damage.
If it appears damaged, or if any items listed below are missing,
contact your LSI Logic support representative. The MegaRAID
320-0X storage adapter is shipped with:
◊
The U320 Driver Suite CD, which contains MegaRAID
drivers for supported operating systems, an electronic