Avago Technologies MegaRAID SCSI 320-0X (530) - Manual (Page 19)

MegaRAID 320-0X Zero-Channel PCI-X RAID Storage Adapter 2-1
Copyright © 2005 by LSI Logic Corporation. All rights reserved.
Chapter 2
MegaRAID 320-0X
Hardware Installation
This chapter describes the procedures for installing the
MegaRAID 320-0X storage adapter. It contains the following sections:
•
Section 2.1, “Requirements,” page 2-1
•
Section 2.2, “Quick Installation,” page 2-2
•
Section 2.3, “Detailed Installation,” page 2-2
•
Section 2.4, “After You Have Installed the Storage Adapter,” page 2-5
2.1 Requirements
The following items are required to install a MegaRAID 320-0X storage
adapter:
•
A host system with the following:
– Motherboard with a special 64-bit, 3.3 V, PCI or PCI-X expansion
slot with an interrupt routing circuitry
– Support for PCI version 2.2 or later, and PCI-X version 1.1 or
later
•
MegaRAID 320-0X storage adapter
•
Ultra, Ultra2, Ultra160, or Ultra320 SCSI hard disk drives (although
backward compatible, SCSI uses the speed of the slowest device on
the bus)
•
The U320 Driver Suite CD with drivers and documentation
LSI Logic strongly recommends using an uninterruptible power supply
(UPS).