EnGenius Technologies DuraFon 4X - Manual (Page 16)

29
2. Broadcasting a group of handsets
a.
Enter the Group ID and then press BROADCAST key
b. Hear bi-bi-beep while the initiating handset broadcast all
handsets within communication coverage
c. Start to speak the message to be broadcasted once you
hear the “beep” sound; the speakerphone of destination
handsets will be opened up
d. Release BROADCAST key to end the broadcasting
3. Broadcasting an individual handset
a.
Enter the Handset ID and then press BROADCAST key
b. Hear bi-bi-beep while the initiating handset broadcast all
handsets within communication coverage
c. Start to speak the message to be broadcasted once you
hear the “beep” sound; the speakerphone of destination
handsets will be opened up
d. Release BROADCAST key to end the broadcasting
Notes:
1.
You need to continuously press BROADCAST key when
doing broadcast. The broadcast will be over once user
release the key.
2. You need to notice that there is no bi-bi-beep sound
when receiving a broadcast.
3. You can press the SILENT (Left) soft key if you choose
to ignore the call. The SILENT key operation is valid only
for the current call. You can silent all broadcast by
turning off the ringer to set auto-silence from the handset
menu.
Redial
1. Press
REDIAL (Left) soft key.
2. The LCD shows the last phone number dialed. To dial this
number, press DIAL (Left) soft key.
3. Use Up or Down Arrow Key to scroll through the last 10 phone
numbers dialed. Select and press DIAL key.
[Note] Intercom numbers (Handset ID) are not stored in the
30
last 10 numbers dialed log.
Receiving a Telephone Call
1. When an incoming call arrives, the ringer will ring or vibrate
unless the ringer has been turned off.
2. If the handset is on the charger cradle (ringer will be
temporarily switched to “Ring” if it has been set to “Vibrate”),
lift the handset and start the conversation.
3. If the handset is not on the cradle, press any key (except END,
and the Silent soft key) to answer.
Notes:
1. You can press SILENT (Left) soft key if you choose to ignore
the call. Unlike turning off the ringer (from the handset menu),
the
SILENT key operation is valid only for the current call.
2. If Caller ID service is available, the LCD will display the
incoming call information. If the LCD shows “Private” or
“Unknown”, the caller’s information may have been blocked by
the caller or the originating phone company.
Receiving an Intercom Call
1. When an intercom call arrives, the ringer will ring or vibrate
unless the ringer has been turned off. Press TALK to answer
the intercom call.
2. If the handset is on the charger cradle (ringer will be
temporarily switched to “Ring” if it has been set to “Vibrate”),
lift the handset and start the conversation.
3. If the handset is not on the cradle, press any key (except END
and the SILENT soft key) to answer.
Notes:
1. The LCD displays the caller’s Handset ID.
2. You can press the
SILENT if you choose to ignore the call. Unlike
turning off the ringer the SILENT key operation is valid only for the
current call.