2 parameters, 3 program return value, 4 sample output – Avago Technologies SAS 9207-4i4e Host Bus Adapter User Manual
Page 8
LSI Corporation
- 8 -
SAS-2 Integrated RAID Configuration Utility (SAS2IRCU) User Guide
November 2012
Commands
3.5.2
Parameters
<controller_#> – The index of the controller for which you want to display information.
[filename] – An optional valid filename to store the command output to a file.
3.5.3
Program Return Value
0x00
SUCCESS: Command completed successfully.
0x01
FAILURE: Bad command-line arguments or operational failure.
0x02
ADAPTER_NOT_FOUND: Cannot find specified adapter.
3.5.4
Sample Output
Following is a sample of the information that the DISPLAY command returns.
Read configuration has been initiated for controller 0
------------------------------------------------------------------------
Controller information
------------------------------------------------------------------------
Controller type : SAS2008
PI Supports : Yes
PI Mixing : Enabled
BIOS version : 7.00.02.00
Firmware version : 00.250.19.0
Channel description : 1 Serial Attached SCSI
Initiator ID : 112
Maximum physical devices : 62
Concurrent commands supported : 266
Slot : 3
Segment : 0
Bus : 64
Device : 1
Function : 0
RAID Support : Yes
------------------------------------------------------------------------
IR Volume information
------------------------------------------------------------------------
IR volume 1
Volume ID : 286
PI Supported : Yes
PI Enabled : Yes
Status of volume : Okay (OKY)
Volume wwid : 0677c0fb06777e7b
RAID level : RAID1
Size (in MB) : 139236
Boot : Primary
Physical hard disks :
PHY[0] Enclosure#/Slot# : 1:0
PHY[1] Enclosure#/Slot# : 1:1
------------------------------------------------------------------------
Physical device information
------------------------------------------------------------------------
Initiator at ID #0
Device is a Hard disk