Avago Technologies MegaRAID SAS 9260-16i - Manual (Page 7)

LSI Corporation Confidential | August 2010 Page 7
MegaRAID LSIiBBU08 Intelligent Battery Backup Unit Quick Installation Guide Connecting the LSIiBBU08 Remotely to the MegaRAID SAS RAID Controller
Figure 3: Reinstalling the MegaRAID SAS 9280-8e RAID Controller
4. Secure the controller to the computer chassis with the bracket screw.
5. Replace the computer cover and reattach the power cords.
6. Turn on the power to the computer.
Connecting the LSIiBBU08
Remotely to the MegaRAID SAS
RAID Controller This section describes the two methods you can use to connect the LSIiBBU08 remotely
to your MegaRAID SAS RAID controller using a cable or, where applicable, a cable and a
remote interposer board that are sold separately in a Remote Battery Kit:
 Use the cable to connect the remote LSIiBBU08 to the BBU connector on the RAID
controller (
Connecting the LSIiBBU08 Remotely to the MegaRAID SAS RAID Controller )
 Use the cable to connect the remote LSIiBBU08 to a daughtercard that is connected
to the BBU connector on the RAID controller (
Connecting the Remote LSIiBBU08 to an
Interposer Card on the MegaRAID SAS RAID Controller )
The procedures in this section show how to connect the LSIiBBU08 remotely to the
MegaRAID SAS 9280-8i RAID controller. You can connect the LSIiBBU08 in the same way
to the other MegaRAID SAS RAID controllers that use this iBBU.
For information about the BBU connectors on these controllers, see the MegaRAID
6Gb/s SAS RAID Controllers User’s Guide.
Connecting the Remote LSIiBBU08 to the
BBU Connector on the RAID Controller This section describes how to connect the remote LSIiBBU08 to the BBU connector on
the SAS 9280-8e RAID controller.
To connect the remote RAID controller to the BBU connector on the RAID controller,
perform the following tasks in order:
Edge of Motherboard
LSIiBBU08 (Top View)
Bracket Screw
Edge of
Motherboard
85065-02
Press Here
Press Here
Model: B
AT 1S 1P
Model: BA
T 1S1P WA RNING:
The battery used in
this device may present a risk of fire or
chemical burn if mistreated. DO NOT
dissemble, heat above 60C, crush or
puncture, short circuit external contacts,
or dispose in fire or water
.
WA RNING:
The battery used in
this device may present a risk of fire or
chemical burn if mistreated. DO NOT
dissemble, heat above 60C, crush or
puncture, short circuit external contacts,
or dispose in fire or water
.
Con tain s: Son y U S45 426 1A 8T Cell
Rec harg eab le L i-P oly me r
Batt ery P ack Ratin g: 3.7 V; 1 .59 Ah; 5 .9W h
Fin ishe d in C hin a
Contains:
Sony US454261A8T
Cell
Rechargeable Li-Polymer
Battery Pack
Rating:
3.7V; 1.59Ah; 5.9Wh
Finished in China
BBU P/N: L4-25343-04 BBU P/N: L4-25343-04
BBU S/N:SY02700225SO
Li-ion
5