Avago Technologies MegaRAID SAS 9260-16i - Manual (Page 6)

Page 6 LSI Corporation Confidential | August 2010
MegaRAID LSIiBBU08 Intelligent Battery Backup Unit Quick Installation Guide Installing the LSIiBBU08 Directly on the MegaRAID SAS RAID Controller
Figure 2: Installing the LSIiBBU08 Daughtercard on the SAS 9280-8e RAID Controller
6. Carefully press the LSIiBBU08 onto the RAID controller so that the two connectors
are firmly joined.
7. Secure the LSIiBBU08 to the RAID controller with the screws and the standoffs in the
three screwholes.
The standoffs are threaded at both ends, and a screw goes into each end. The screw
threads from the back of the controller board into the board-to-board standoffs on
the bottom of the LSIiBBU08.
CAUTION: Center the screwdriver carefully to avoid stripping the screw heads. Do not
overtighten the screws.
Reinstalling the RAID Controller on the
Motherboard Follow these steps to reinstall the RAID controller on a motherboard.
1. With the power to the chassis still turned off, and the power cords unplugged, make
sure the chassis is grounded and has no AC power.
2. Install the RAID controller in a PCI Express slot on the motherboard, as shown in
Figure 3 .
NOTE: Some PCI Express slots support only PCI Express graphics cards; if a RAID
controller is installed in one of these slots, it will not function. Refer to your computer
documentation for information about the PCI Express slot.
3. Press down gently but firmly to seat the card correctly in the slot.
85065-01
J6B1
Model: BA
T1S1P
WARNING:
The battery
used
in
this
devic
e may
present
a risk
of fire or
chemic
al burn if mistreated.
DO NOT
dissemble, heat above
60C, crus
h or
puncture,
short
circuit external
contac
ts,
or dispos
e in fire or water
.
Con tain s:
Son y U S45 426 1A 8T Cell
Rec har gea ble Li- Poly me r
Batt ery P ack
Ratin g:
3.7 V; 1 .59 Ah; 5 .9W h
Fin ishe d in C hin a
BB U P /N : L4-2
53 43-04
BB U S /N :S Y027
002 25 SO Li-ion