Avago Technologies MegaRAID SAS 9260-16i - Manual (Page 12)

Page 12 LSI Corporation Confidential | August 2010
MegaRAID LSIiBBU08 Intelligent Battery Backup Unit Quick Installation Guide Connecting the LSIiBBU08 Remotely to the MegaRAID SAS RAID Controller
Figure 6: Connecting the Interposer Card to the MegaRAID SAS 9260-8i RAID Controller
Connecting the Cable Between the
Interposer Card and the LSIiBBU08
Follow these steps to connect the cable between the interposer card on the controller
and the LSIiBBU08.
1. Mount the LSIiBBU08 to the chassis of your computer based on the location and the
type of mounting option.
2. With the controller on a flat, clean, static-free surface, ground yourself and make
sure the system is grounded.
3. Remove the cable included in the Remote Battery Kit (sold separately).
4. Insert one end of the cable into the 20-pin J2 connector on the LSIiBBU08 and the
other end into the 20-pin J1 connector on the interposer card, as shown in Figure 7 .
Align the black triangles on the connectors to make sure they are connected
properly.
NOTE: The cable connectors are polarized and can be inserted into the connectors on
the interposer card and the LSIiBBU08 only if the rails on the cable connectors align with
the slots on the other connectors. Do not force the cable into the 20-pin connectors. The
cable end inserts into the connector with minimal resistance.
85039-07