Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 7)

LSI Corporation
- 7 -
LSICVM02 Kit Quick Installation Guide
May 2014 Installing the LSICVM02 Kit
Installing the Clip on the Remote Mount Board
Installing the Clip on the Remote Mount Board
Follow these steps to attach the clip to a BBU-BRACKET-05 remote mount board.
1. With the remote mount board on a flat, clean, static-free surface, ground yourself, and make sure that the system
is grounded.
2. Remove the clip and the remote mount board module from the package.
3. Place the clip and the remote mount board module front-side-up on a flat, clean, static-free surface.
4. Hold the clip so the screw holes on the clip line up with the screw holes on the remote mount board, as shown in
the following figure.
Figure 4 Installing the Clip on the Remote Mount Board
5. Secure the clip to the three screw holes with the screws and the nuts.
The screws thread through the front of the clip and the remote mount board.
NOTE Center the screwdriver carefully to avoid stripping the screw heads. Do
not over-tighten the
screws.
A
A
A
Clip
3_00895b-00