Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 10)

LSI Corporation
- 10 -
LSICVM02 Kit Quick Installation Guide
May 2014 Installing the LSICVM02 Kit
Reinstalling the RAID Controller on the Motherboard
Reinstalling the RAID Controller on the Motherboard
Follow these steps to reinstall your MegaRAID SAS 9361-8i RAID controller in a PCIe slot on the motherboard.
1. Make sure that the power to the chassis is still turned off, the power cords are unplugged, and the chassis is
grounded and has no AC power.
2. Install the RAID controller in a PCIe slot on the motherboard, as shown in the following figure.
NOTE Some PCIe slots support only PCIe graphics cards; a remote mount
board installed in one of these slots will not function. Refer to your
computer documentation for information about the PCIe slot.
3. Press down gently, but firmly, to seat the card correctly in the slot.
4. Secure the controller to the computer chassis with the bracket screw.
Figure 7 Reinstalling the RAID Controller
Press
Here
3_01658-04
Edge of
Motherboard
PCIe Slot
Bracket
Screw
Press
Here
CacheVault
Power Module 02
(CVPM02)
CacheVault
Flash Module 04
(CVFM04)
Remote Mount
Board