Enterasys Networks SecureStack C2 C2RPS-POE - Manual (Page 22)

Unpacking the C2RPS-POE
2-2 Installation
Unpacking the C2RPS-POE
To unpack the C2RPS‐POE, proceed as follows:
1. Open the box and remove the packing material protecting the devices.
2. Verify the contents of each carton and compare the contents shipped with those listed
in
Table 2‐1 .
3. Perform a visual inspection of the devices for any signs of physical damage. Contact
Enterasys Networks if there are any signs of damage. Refer to “
Getting Help ” on
page 1‐4 for details.
Installing the C2RPS-POE on a Flat Surface
When installing the switch on a flat surface, the installation of the rubber feet is
recommended to prevent the C2RPS‐POE from sliding on a flat surface. Installing the
rubber feet is optional if you are installing the C2RPS‐POE in a rack. To install the rubber
feet, proceed to
Installing the Rubber Feet instructions below. For instructions to rack
mount the switch, proceed to “ Rack Mounting the C2RPS‐POE ” on page 2‐5.
Table 2-1 Contents of N-POE Chassis Carton
Item Quantity
C2RPS-POE Cable 1
Rubber Foot 4
Flathead screw M3x6 6
Rack mount bracket 1
USA, NEMA Power Cord 1
Installation guide 1
Release Notes 1
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.