DE DIETRICH LZ9619E1 - Manual (Page 7)

Installation
Unpacking
All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit devices
so that they can be refitted if the machine
ever has to be transported again.
1. Using a spanner, unscrew and remove
the rear right-hand bolt and lay the
machine on its back, taking care not to
squash the hoses. This can be avoided
by placing one of the corner packing
pieces between the machine and the
floor.
2. Remove the polystyrene base and take
off the bottom panel by unscrewing the
central screw.
3. Carefully remove the right-hand bag.
P0015 P0457
P0255
4. Carefully slide out the other bags.
5. Re-fit the bottom panel using the 4
screws supplied with the door hinges
(in the plastic bag) and the previously
removed screw.
6. Set the machine upright and remove the
two remaining bolts from the back.
7. Pull out the three plastic spacers from
the holes into which the bolts were fitted.
8. Plug the open holes with the plugs which
are supplied with the instruction booklet.
P0020 P0256
P0453 P0016
GB
7