DE DIETRICH LZ9619E1 - Manual (Page 14)

Use
12 Display
The display shows the following information:
• if the programme selector dial is on the
RESET position, three flashing dashes
appear immediately after pressing the
ON/OFF button to indicate that the machine
is ready to receive instructions for the
required wash programme.
• Duration of the selected wash
programme, calculated automatically on
the basis of the maximum recommended
load for each type of fabric.
• Selected drying time (max. 2 hours and
10 minutes for cotton, 1 hour and 40
minutes for synthetics).
After the programme has started, the time
remaining is updated every 10 minutes,
and every 5 minutes during the last 20
minutes.
• When the programme has finished, three
flashing zeros are displayed.
• Delayed start, programmed using the
special button .
The countdown is updated every hour,
and every 5 minutes during the last hour.
• Heating phase. A dot to the right of the
figures in the display indicates that the
machine is heating the water.
• Incorrect option selection. If an option
which is not compatible with the set wash
programme is selected, the message Err
is displayed.
1
13 START/PAUSE button
This button has three functions:
a) Start
After having selected the required
programme, press this button to start the
machine; the corresponding pilot light stops
flashing.
b) Pause
To interrupt a programme which is running,
press the START/PAUSE button: the
corresponding pilot light and the light of the
programme phase which is running will start
to flash.
To restart the programme from the point at
which it was interrupted, press the
START/PAUSE button again.
c) Empty out water
At the end of a programme which ends with
water in the drum (RINSE HOLD
option),
or after the “soak” programme , press the
START/PAUSE button to empty out the water:
after the soak programme, the machine will
empty only; after RINSE HOLD programmes,
the machine will empty and spin.
14 Programme progress display
By selecting the wash programme, the pilot
lights corresponding to the various phases
making up the programme come on.
After the machine has started, only the
running phase pilot light stays on. When the
programme has finished, the STOP pilot
light comes on.
Prewash
Wash
Rinses
Rinse hold
Pump out
Spin
Dry
End STOP
GB
14