Epson 485Wi - Manual (Page 200)

• Press one of the Source buttons on the remote control to select the source for the image you want to
annotate. To use a blank screen, select Computer2 or another unused source
Note: You cannot use the built-in toolbar if you select the same source that is selected for Easy
Interactive Tools in the Extended menu.
• Make sure you have calibrated the system. Try recalibrating.
Parent topic: Solving Interactive Pen Problems
Related references
Projector Setup Settings - Extended Menu
Solutions When the Interactive Pen Position Is Not Accurate
If the pen position is not the same as the cursor, try the following solutions:
• Make sure you have calibrated the system. Try manual calibration.
• Make sure the cable cover is in place to keep cables from blocking the signal.
• Try adjusting the pen operation area.
• If you use the E-Zoom + button on the remote control to enlarge the image, the pen position is not
accurate. When you return to the original size, the position should be correct.
Parent topic: Solving Interactive Pen Problems
Related tasks
Adjusting the Pen Operation Area
Calibrating Automatically
Calibrating Manually
Solutions When the Interactive Pens Are Slow or Difficult to Use
If the pens are difficult to use or respond too slowly, try the following solutions:
• For easier operation, hold the pen perpendicular to the projection surface.
• For the best performance, connect your computer to the projector using a VGA computer cable for
display and the USB cable for interactivity.
• If you are using USB display in Windows, you may need to disable Windows Aero in the EPSON USB
Display Settings program on your computer.
Parent topic: Solving Interactive Pen Problems
200