5 tools required – EFJohnson VR-CM50 User Manual
Page 10
PRE-INSTALLATION INFORMATION
1-2
February 1996
Part No. 004-3039-274
1.1.5 TOOLS REQUIRED
The following tools are needed for the mechani-
cal assembly and installation of the VR-CM50 Con-
sole System:
1/4" Flat Blade Screwdriver
#1 Phillips Screwdriver
#2 Phillips Screwdriver
7/16" Open End Wrench
3/8" Nut Driver
3/16" Ball Point Driver
3/8" Square Drive 3/16" Hex Bit
If you are installing cabinetry, the tools required
for those assemblies are listed in Section 3.
3/16" Hex Key
3/8" Square Drive 7/16" Socket
3/8" Drive Ratchet Wrench
Wire Strippers
Carpenter’s Level
Hand Terminal Crimp Tool - "Champ" Tool
Figure 1-1 HARDWARE INCLUDED FOR INSTALLATION AND ASSEMBLY