Whelen FNMINI - Manual (Page 6)

Page 6
Lighthead Mounting Bracket
Ears on mounting
bracket slide into
the channels in
the extrusion.
Place the endcap gasket into position on the endcap, locating all tabs and holes. Align the reflector assembly of the alley light with
the 4 bosses in the endcap and press the reflector in place until the 4 barbs engage around the reflector.
Installing Endcap Gasket & Alley Light
GASKET
LIGHTHEAD
BARB
Remove the four screws (A) that hold the endcap on and pull
the endcap and gasket (C) off.
(B)
Slide the lenses (D) out of the
lightbar, to gain access to the extrusion. When reinstalling
the endcap, first place the gasket into position on the
endcap. Be sure to line up all the tabs and holes
on the gasket.
Removing the Endcap and Lenses
A
D
B
C
TOP VIEW OF EXTRUSION END VIEW OF EXTRUSION
Installing a Corner LED
Slide Spacer in here
Snap lighthead into bracket here Extrusion
CENTER OF EXTRUSION
LIGHTHEAD
EXTRUSION
BOSS
Front
Passenger
Front
Passenger
Lighthead Tabs
slide into extrusion
The edge of the lighthead snaps into the
clips on the mounting bracket.
Lighthead mounting
holes snap into the
raised bosses on
mounting bracket.
CORNER
LED
Note: Should you need to service or repair your lightbar, the diagrams below will show you how to gain access.