Whelen SAK49 - Manual (Page 2)

Page 2
Installation 2014 Silverado 1500:
This bracket mounts to the front radiator support. There is a
bracket available for either the driver or passenger side of the
vehicle. The passenger side is shown here.
1. Remove bumper cover / grill assembly to access the
mounting area. Follow manufacturer instructions (Fig. 1).
2. Mount the siren speaker to the bracket using the supplied 1/4
- 20 X 1-1/4” HEX HEAD BOLTS and 1/4” SPLIT LOCK
WASHERS (Fig. 2).
3. Remove the bolt indicated in figure 1 which secures the front
radiator support. Slide the top of the MOUNTING BRACKET
behind the radiator support and replace the bolt to secure the
top of the bracket (Figs. 2 & 3).
4. Position the BRACKET CLAMP around the support indicated
in figures 1 & 2 and secure it to the MOUNTING BRACKET
with the supplied 1/4 - 20 X 1” HEX HEAD CAP SCREWS
and 1/4” FLAT WASHERS.
5. After testing the siren speaker, replace the bumper cover /
grill assembly you removed in step 1 following manufacturers
instructions.
6. Extend the siren speaker wires to your power source and
connect as described in your siren speaker manual.
installation is complete. Make sure you keep the speaker
wires away from the radiator and any other engine parts
which might result in damage to the wires or vehicle.
Caution: It is the responsibility of the installation technician
to make sure that the installation and operation of this
product will not interfere with or compromise the operation
or efficiency of any vehicle equipment! It is left to the
installation technician's discretion to select a path for the
wires that will both protect the wires from possible damage
and not interfere with the operation of any other vehicle
components or equipment. Before returning the vehicle to
active service, visually confirm the proper operation of this
product, as well as all vehicle components/equipment.