beautypg.com

Installation – Whelen SAK54 User Manual

Page 2

background image

Page 2

Installation:

1.

Remove the front nose assembly from the vehicle following
factory instructions.

2.

Mount the siren speaker to the bracket using the supplied
hardware (Figs. 1 & 2).

3.

Remove the hardware which secures the two support struts
in front of the radiator (Fig. 3).

4.

Remount the support struts over the speaker bracket using
the existing strut hardware to secure the speaker bracket
(Fig. 4).

5.

Extend and connect the positive (WHITE) and negative
(BLACK) speaker wires to your siren amplifier.

6.

After testing speaker operation, remount the vehicle nose
assembly following manufacturer instructions.

IMPORTANT! It is the responsibility of the installation
technician to make sure that the installation and operation of
this product will not interfere with or compromise the
operation or efficiency of any vehicle equipment! Before
returning the vehicle to active service, visually confirm the
proper operation of this product, as well as all vehicle
components/equipment.

IMPORTANT: The speaker must be oriented so the wire passage
hole is in the “6 o’clock” position (closest to the road). This hole
also serves as the drain hole for the siren. Improper mounting will
result in premature driver failure and void the product warranty.

The speaker is shipped with two

installed,

holding the speaker together.

be sure to hold the driver securely in place when

you remove the screws. Remove both

and secure the

speaker to the bracket

1-1/4" hex head screws

You must replace both screws with

the longer

(Supplied) to mount the speaker

to the bracket. Since the existing screws are holding the siren
driver in place

screws

with a

and

1-1/2 hex head screws

1-1/2" screw

1/4" split lock

. Tighten firmly to secure

the driver and then install the
other three

and

.

washer

1-1/2" screws

1/4" split lock washers

SA315 / Rear V

iew

Mounting the speaker to the bracket

Wire Exit / Drain Hole

REPLACE BOLTS

Fig. 2

Fig. 1

1/4 - 20 X 1-1/2"
Hex Head Screw

1/4 - 20 X 1-1/2"
Hex Head Screw

1/4 - 20 X 1-1/2"
Hex Head Screw

1/4" Split
Lock Washer

1/4" Split
Lock Washer

1/4" Split
Lock Washer