Whelen SAK42 - Manual (Page 2)

Page 2
SA315 / Rear View
wire
exit &
drain
hole
A
A
A A
position (closest to the road). This is also the drain hole for the siren. Improper mounting
will result in premature driver failure and void the product warranty.
IMPORTANT: For drainage purposes, the speaker must be
oriented so that the wire passage hole is in the “6 o’clock”
The SA315 siren speaker mounting kit comes with 3 long bolts
(1/4-20 X 1-1/4” PFHMS). The longer bolts are necessary to go
through the mounting bracket, the siren housing and into the
siren driver. They will replace 3 of the 4 short bolts (“A”) that
now secure the siren driver to the speaker housing. Your
speaker is shipped with 2 of the shorter bolts installed.
A short bolt be used in the hole that go
through the bracket so it will properly secure the driver to
the housing. If you need to remove all 4 bolts at once be
sure to hold the driver securely in place.
must does not
1/4 - 20 X 1-1/4"
HEX HEAD SS
1/4" SPLIT
LOCKWASHER
1/4 - 20 X 1-1/4"
PFHMS
1/2 - 13
ELASTIC
STOP NUT
BUMPER
SUPPORT
1/2"
FLAT
WASHER
1/2 - 13 X 1-1/4
HEX HD BOLT
BUMPER
SUPPORT
CONDENSER
BRACKET
SIREN SPEAKER
MOUNTING
HOLES
Installation:
This bracket will mount behind the grill, to the bumper support. It can
be mounted to either the driver or passenger side. The bracket
mounts to two existing holes in the bumper support. 1. Mount the siren speaker to the mounting bracket as shown at the top
of the page. Tighten all mounting hardware firmly.
2. Find the bumper support you will mount to (behind the front grill).
Locate the 2 existing mounting holes. The illustration shows the
mounting area from the ground, looking up at the vehicle, with the
speaker and bracket.
3. Slide the speaker with bracket up from the bottom of the vehicle, into
its mounting location. Secure the speaker bracket to the vehicle
using the supplied Hex head bolts, flat washers and stop nuts as
shown at the top of the page.
4. Extend the WHITE (positive) and BLACK (negative) wires to your
siren amplifier and connect as described in the amplifiers
instructions.
IMPORTANT! It is the responsibility of the installation technician to
make sure that the installation and operation of this product will not
interfere with or compromise the operation or efficiency of any
vehicle equipment!
IMPORTANT! Before returning the vehicle to active service, visually
confirm the proper operation of this product, as well as all vehicle
components/equipment.