Whelen SAK38 - Manual (Page 2)

Page 2
Fig. 3
Installation: 2010 Ford Fusion
1. Remove the protective cover just behind the front
bumper to access the hood latch assembly (Fig. 1).
2. Remove the 2 bolts that hold the hood latch assembly
on and set it aside (do not disconnect the cables).
3. Secure the siren speaker to the mounting bracket
(Fig. 2) (See speaker mounting information below).
4. The bracket mounts behind the hood latch assembly
using the hood latch’s mounting hardware (Fig. 3).
5. Be sure all the hood latch cables are properly located, then secure the hood latch assembly
(Over the siren bracket) using the hood latch assembly bolts. IMPORTANT: Make sure the
two bolt heads line up with the two indentations on the hood latch assembly made by
the bolts original position, so that the hood latch assembly reinstalls in the same
position and lines up properly with the hood.
6. Extend WHITE (positive) and BLACK (negative) speaker wires to your siren amplifier and
connect as shown in the amplifiers instructions.
Caution: It is the responsibility of the
installation technician to make sure
that the installation and operation of
this product will not interfere with or
compromise the operation or
efficiency of any vehicle equipment!
Before returning the vehicle to active
service, visually confirm the proper
operation of this product, as well as all
vehicle components/equipment.
IMPORTANT: For drainage purposes, the speaker must be oriented so that the wire passage hole is in the “6 o’clock”
position (closest to the road).This is also the drain hole for the siren. Improper mounting will result in premature driver
failure and void the product warranty.
The SA315 siren speaker mounting kit comes with 3 long bolts (1/4-20 X 1-1/2” Hex Head).
The longer bolts are needed to go through the mounting bracket, the siren housing and
into the siren driver. They will replace 3 of the 4 shorter bolts (“A”) that now secure the
siren driver to the speaker housing. The speaker is shipped with the shorter bolts
installed. A short bolt be used in the hole that go through the bracket so it
will properly secure the driver to the housing. If you need to remove all 4 bolts at once be
sure to hold the driver securely in place.
must does not wire
exit &
drain
hole
A
A
A A
SA315 / Rear View
Refer to OSHA Section 1910.95 prior
to putting ANY siren into service!
Loud siren noise can cause
hearing damage and/or loss.
C A U T I O N
Wear
Protection!
ACTIVATION OF THIS
SIREN MAY DAMAGE
UNPROTECTED EARS!
Fig. 2
wire passage
/drain hole
1/4 - 20 X 1-1/2"
HEX HEAD SS
1/4 X 20 X 1-1/4
HEX HEAD
SA315
1/4" SPLIT
LOCK WASHER
1/4" SPLIT
L O C K
WASHER
mount
behind
hood
latch
assembly