Whelen SAK20 - Manual (Page 2)

Page 2
SA315 / Rear View
wire
exit &
drain
hole
A
B
A A
The SA315 siren speaker mounting kit includes three,1/4-20 X 1 1/4” screws. These
screws will replace the 3 screws marked “A”. These are used to secure the siren
driver to the speaker housing during shipping. One of the 4 screws is not used to
secure the siren to the bracket. In the orientation shown, this screw is marked “B”.
This screw
remain installed to properly secure the driver to the housing. If you
need to remove all 4 screws at once, be sure to hold the siren driver securely in place
until the screws are reinstalled.
must
IMPORTANT: For drainage purposes, the speaker must be oriented so that the wire
passage hole is in the “6 o’clock” position (closest to the road). This is also the
drain hole for the siren. Improper mounting will result in premature driver failure
and void the product warranty.
1/4-20 X 1-1/4"
Phillips Flat Head
Machine Screw
SA315
SA315 / Rear View
wire
exit &
drain
hole
A
B
A A
The SA315 siren speaker mounting kit includes three,1/4-20 X 1 1/4” screws. These
screws will replace the 3 screws marked “A”. These are used to secure the siren
driver to the speaker housing during shipping. One of the 4 screws is not used to
secure the siren to the bracket. In the orientation shown, this screw is marked “B”.
This screw
remain installed to properly secure the driver to the housing. If you
need to remove all 4 screws at once, be sure to hold the siren driver securely in place
until the screws are reinstalled.
must
IMPORTANT: For drainage purposes, the speaker must be oriented so that the wire
passage hole is in the “6 o’clock” position (closest to the road). This is also the
drain hole for the siren. Improper mounting will result in premature driver failure
and void the product warranty.
1/4-20 X 1-1/4"
Phillips Flat Head
Machine Screw
SA315
Note: Permanent mounting of this product will require drilling. It is absolutely necessary to make sure that no
other vehicle components could be damaged by this process. Check both sides of the mounting surface before
starting. If damage is likely, select a different mounting location.
IMPORTANT! It is the responsibility of the installation technician to make sure that the installation and operation
of this product will not interfere with or compromise the operation or efficiency of any vehicle equipment!
IMPORTANT! Before returning the vehicle to active service, visually confirm the proper operation of this product,
as well as all vehicle components/equipment.
IMPORTANT! It is the responsibility of the installation technician to make sure that the installation and operation of this product will notinterfere with or
compromise the operation or efficiency of any vehicle equipment! Before returning the vehicle to active service, visually confirm the proper operation of this
product, as well as all vehicle components and equipment.
DANGER! Sirens produces extremely loud emergency warning tones! Exposure to these tones without proper and adequate hearing
protection, could cause ear damage and/or hearing loss! The Occupational Safety & Health Administration (www.osha.gov) provides
information necessary to determine safe exposure times in Occupational Noise Exposure Section 1910.95. Until you have determined the safe
exposure times for your specific application, operators and anyone else in the immediate vicinity should be required to wear an approved
hearing protection device. FAILURE TO FOLLOW THIS RECOMMENDATION COULD CAUSE HEARING LOSS!
Note: Permanent mounting of this product will require drilling. It is absolutely necessary to make sure that no
other vehicle components could be damaged by this process. Check both sides of the mounting surface before
starting. If damage is likely, select a different mounting location.
IMPORTANT! It is the responsibility of the installation technician to make sure that the installation and operation
of this product will not interfere with or compromise the operation or efficiency of any vehicle equipment!
IMPORTANT! Before returning the vehicle to active service, visually confirm the proper operation of this product,
as well as all vehicle components/equipment.
IMPORTANT! It is the responsibility of the installation technician to make sure that the installation and operation of this product will notinterfere with or
compromise the operation or efficiency of any vehicle equipment! Before returning the vehicle to active service, visually confirm the proper operation of this
product, as well as all vehicle components and equipment.
DANGER! Sirens produces extremely loud emergency warning tones! Exposure to these tones without proper and adequate hearing
protection, could cause ear damage and/or hearing loss! The Occupational Safety & Health Administration (www.osha.gov) provides
information necessary to determine safe exposure times in Occupational Noise Exposure Section 1910.95. Until you have determined the safe
exposure times for your specific application, operators and anyone else in the immediate vicinity should be required to wear an approved
hearing protection device. FAILURE TO FOLLOW THIS RECOMMENDATION COULD CAUSE HEARING LOSS!