beautypg.com

Page 2, Danger – Whelen SAK9 User Manual

Page 2

background image

Page 2

SA315 / Rear View

wire

exit &

drain

hole

A

B

A

A

IMPORTANT: For drainage purposes, the speaker must be oriented so that the wire

passage hole is in the “6 o’clock” position (closest to the road).This is also the drain

hole for the siren. Improper mounting will result in premature driver failure and void

the product warranty.

The SA315 siren speaker mounting kit comes with 3 long bolts (1/4-20 X 1-1/2” HEX HD) shipped

seperately. The longer bolts are necessary to go through the mounting bracket, siren housing and

into the siren driver ("A").

. Do not remove the bottom short bolt. This bolt will

hold the driver and housing together. At

Your speaker is shipped with 2 short bolts installed on the top and

bottom of the speaker. Remove the short bolt on top and replace it with a long bolt

when mounting to the bracket

least 1 short bolt

be used in the hole

that

go through the bracket so it will properly secure the driver to the housing.

must

does not

1/4 - 20 X

1-1/2 HEX HD

(Speaker &

Bracket)

1/4" SPLIT

LOCKWASHER

(Speaker &

Bracket)

1/4 X 20 X 1-1/4 HEX HEAD

1/4" SPLIT LOCK WASHER

(Speaker Only) DO NOT REMOVE!

IMPORTANT Before returning the vehicle to active service, confirm the proper operation of this product, as well as all vehicle components or

equipment. It is the responsibility of the installation technician to make sure that the installation and operation of this product will not interfere

with or compromise the operation or efficiency of any vehicle equipment!

Sirens produce extremely loud emergency warning tones! exposure to these tones without proper and adequate hearing protection, could

cause ear damage and/or hearing loss! The Occupational Safety & Health Administration (www.osha.gov) provides information necessary to determine

safe exposure times in Occupational Noise Exposure Section 1910.95. Until you have determined the safe exposure times for your specific application,

operators and anyone else in the immediate vicinity should be required to wear an approved hearing protection device.

FAILURE TO FOLLOW THIS RECOMMENDATION COULD CAUSE HEARING LOSS!

DANGER!

SA315 / Rear View

wire

exit &

drain

hole

A

B

A

A

IMPORTANT: For drainage purposes, the speaker must be oriented so that the wire

passage hole is in the “6 o’clock” position (closest to the road).This is also the drain

hole for the siren. Improper mounting will result in premature driver failure and void

the product warranty.

The SA315 siren speaker mounting kit comes with 3 long bolts (1/4-20 X 1-1/2” HEX HD) shipped

seperately. The longer bolts are necessary to go through the mounting bracket, siren housing and

into the siren driver ("A").

. Do not remove the bottom short bolt. This bolt will

hold the driver and housing together. At

Your speaker is shipped with 2 short bolts installed on the top and

bottom of the speaker. Remove the short bolt on top and replace it with a long bolt

when mounting to the bracket

least 1 short bolt

be used in the hole

that

go through the bracket so it will properly secure the driver to the housing.

must

does not

1/4 - 20 X

1-1/2 HEX HD

(Speaker &

Bracket)

1/4" SPLIT

LOCKWASHER

(Speaker &

Bracket)

1/4 X 20 X 1-1/4 HEX HEAD

1/4" SPLIT LOCK WASHER

(Speaker Only) DO NOT REMOVE!

IMPORTANT Before returning the vehicle to active service, confirm the proper operation of this product, as well as all vehicle components or

equipment. It is the responsibility of the installation technician to make sure that the installation and operation of this product will not interfere

with or compromise the operation or efficiency of any vehicle equipment!

Sirens produce extremely loud emergency warning tones! exposure to these tones without proper and adequate hearing protection, could

cause ear damage and/or hearing loss! The Occupational Safety & Health Administration (www.osha.gov) provides information necessary to determine

safe exposure times in Occupational Noise Exposure Section 1910.95. Until you have determined the safe exposure times for your specific application,

operators and anyone else in the immediate vicinity should be required to wear an approved hearing protection device.

FAILURE TO FOLLOW THIS RECOMMENDATION COULD CAUSE HEARING LOSS!

DANGER!