Whelen MBADPT14 User Manual

Automotive: miscellaneous

Page 1

5/16 x 1 1/4” Hex Head Bolt

Flat Washer

5/16” Elastic Stop Nut

Adapter Plate

Rear Rack

Automotive:

Miscellaneous

Installation Guide:

Adapter Plate MBADPT14

for Harley-Davidson® Motorcycles

ENGINEERING COMPANY INC.

Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: [email protected]
Customer Service e-mail: [email protected]

For warranty information regarding this product, visit www.whelen.com/warranty

51 Winthrop Road,

Chester, Connecticut 06412-0684

Phone: (860) 526-9504

Fax: (860) 526-4078

Installation:

Using an appropriately sized bit, drill a clearance hole for a 5/16
bolt through the existing mounting holes in the rear rack.

Position the adapter plate onto the rear rack so that its holes are
aligned with the rack holes.

Secure the plate loosely to the rack using the hardware provided.
Install hardware in the order shown.

Tighten the hardware in a criss-cross pattern until a torque value of
138 in/lbs (11.5 ft/lbs) is achieved.

Secure new deck with existing hardware

Secure Adapter Plate using the hardware provided.

IMPORTANT!

It is the responsibility of the installation technician

to make sure that the installation and operation of this product will
not interfere with or compromise the operation or efficiency of any
vehicle equipment!
IMPORTANT! Before returning the vehicle to active service, visually
confirm the proper operation of this product, as well as all vehicle
components/equipment.