Whelen M04ZB - Manual (Page 2)

Page 2
Simultaneous
Simultaneous
3 Amp fuse
5 Amp fuse
(TIR3 models)
(LINZ6 models)
RED
BLACK
GREY
to +12VDC
to Ground
Sync
(+)
Battery
(-)
CAUTION! DO NOT LOOK DIRECTLY AT
THESE LEDS WHILE THEY ARE ON.
MOMENTARY BLINDNESS AND/OR EYE
DAMAGE COULD RESULT!
IMPORTANT WARNING!
Remove these 3 screws
to remove windshield and
loosen the upper facia.
Mounting Location
Remove these 4 screws
from the rear of the faring
and remove the facia from
the motorcycle.
Mounting
IMPORTANT! The lightbar should be located a
minimum of 16" from any radio antennas!
This product is designed to mount in the lowest, visable
section of the motorcycle windshield. The mounting
procedure requires removal of the front facia panel of the
motorcycle.
1. Remove the 3 screws along the base of the
windshield from the upper section of the faring facia
panel.
2. Remove the 4 remaining screws (shown above) that
secure the facia panel to the faring. With these
screws removed, the facia and windshield can now
be removed from the motorcycle faring.
3. Position the lightbar into its mounting position. The
base of the lightbar fits onto the three screw bosses
used by the screws removed in step 1.
4. With the facia panel removed, the lightbar should
now be wired.
5. Route the wires to their respective destinations. It is
left to the installation technician's discretion to select
a path for these wires that will both protect them
from possible damage and not interfere with the
operation of any other vehicle components or
equipment.
6. Using the original hardware removed in steps 1 & 2,
remount the faring and windshield according to the
motorcycle manufacturers service manual.
IMPORTANT! Before returning the vehicle to active
service, visually confirm the proper operation of this
product, as well as all vehicle components/
equipment.
WARNING! All customer supplied wires that connect to the positive
terminal of the battery must be sized to supply at least 125% of the
maximum operating current and FUSED at the battery to carry that
load. DO NOT USE CIRCUIT BREAKERS WITH THIS PRODUCT!