Whelen WS321B9 - Manual

Page 1
Fig. 1
©2009 Whelen Engineering Company Inc.
Form No.14276 (031909)
Au
to
mo
tive
:
Sirens & Switches
Installation Guide:
Harley-Davidson® Crash Bar Mounting Bracket
for the Model WS321 Siren Amplifier
®
ENGINEERING COMPANY INC.
For warranty information regarding this product, visit www.whelen.com/warranty
Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: [email protected]
Customer Service e-mail: [email protected] 51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
Installation:
1. Hook the top of the bracket over the top of the crash bar as
shown in figure 1.
2. Secure the top of the bracket with the supplied bolt, flat washer
and spacer in the order shown (Fig. 2).
3. Slip the loop clamp around the bottom of the crash bar and
secure the bottom of the bracket to the loop clamp with the
supplied wing screw and flat washer (Fig. 2).
4. Secure the siren to the bracket with the 4 bolts included with the
siren (Fig. 2).
5. Make sure all hardware is tightened firmly and extend the siren
wires to their power source (Refer to the sirens instructions for
hookup and voltage).
IMPORTANT! It is the responsibility of the installation
technician to make sure that the installation and operation of
this product will not interfere with or compromise the operation
or efficiency of any vehicle equipment!
IMPORTANT! Before returning the vehicle to active service,
visually confirm the proper operation of this product, as well as
all vehicle components/equipment.
Fig. 1
©2009 Whelen Engineering Company Inc.
Form No.14276 (031909)
Au
to
mo
tiv
e:
Sir
e
ns
& Switches
Installation Guide:
Harley-Davidson® Crash Bar Mounting Bracket
for the Model WS321 Siren Amplifier
®
ENGINEERING COMPANY INC.
For warranty information regarding this product, visit www.whelen.com/warranty
Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: [email protected]
Customer Service e-mail: [email protected] 51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
Installation:
1. Hook the top of the bracket over the top of the crash bar as
shown in figure 1.
2. Secure the top of the bracket with the supplied bolt, flat washer
and spacer in the order shown (Fig. 2).
3. Slip the loop clamp around the bottom of the crash bar and
secure the bottom of the bracket to the loop clamp with the
supplied wing screw and flat washer (Fig. 2).
4. Secure the siren to the bracket with the 4 bolts included with the
siren (Fig. 2).
5. Make sure all hardware is tightened firmly and extend the siren
wires to their power source (Refer to the sirens instructions for
hookup and voltage).
IMPORTANT! It is the responsibility of the installation
technician to make sure that the installation and operation of
this product will not interfere with or compromise the operation
or efficiency of any vehicle equipment!
IMPORTANT!Before returning the vehicle to active service,
visually confirm the proper operation of this product, as well as
all vehicle components/equipment.