Whelen WS321B14 - Manual (Page 2)

Page 2
Installation:
1. Following manufacturers instructions, remove the (road
side) saddlebag.
2. Clip the “P” clamp over the crash bar (Figs. 1 & 2).
3. Position the bracket over the top of the crash bar. Place the
spacer between the flat of the bracket and the tab, aligned
with the hole and pem nut.
4. Place the washer over the bolt and thread it through the
spacer and into the pem nut (do not tighten).
5. Align the thumb screw through the fender washer, through
the “P” clamp and thread it into the corresponding pem nut.
6. Tighten the bolt and thumb screw until secure. Re-instalol
the saddle bag.
7. Secure the siren to the bracket with the 4 bolts included
with the siren (Fig. 2).
8. Make sure all hardware is tightened firmly and extend the
siren wires to their power source (Refer to the sirens
instructions for hookup and voltage).
IMPORTANT!It is the responsibility of the installation
technician to make sure that the installation and operation of
this product will not interfere with or compromise the
operation or efficiency of any vehicle equipment!
IMPORTANT!Before returning the vehicle to active service,
visually confirm the proper operation of this product, as well
as all vehicle components/equipment.
SIREN
AMPLIFIER
CRASH BAR
FRONT
of BIKE
7/8 LOOP
(P) CLAMP
5/16 - 18 X 3/4"
WING SCREW
5/16 FLAT
WASHER
Fig. 2
5/16 - 18 X 1-1/4
HEX HD BOLT
5/16 FLATWASHER
SPACER
Siren mounting
screws (Qty 4)