Whelen RBKTHD6 - Manual

Page 1
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
Installation:
1. Remove the clamp ring from the fog light and lift the fog light out. Unscrew both wire terminals, cut the fork
terminal off of the end of the GREY-BLACK wire and set the light aside.
2. Remove both allen-head screws from the passing light mounting bracket and unscrew the nut holding the wire
guide. Carefully lower the light and let it hang while you slide the grey fog light wire out of the bottom of the tube.
3. Remove the washer indicated and replace it with the lighthead mounting bracket.
Reassembly:
1. Thread the fog light wire up through the guide tube until it protruds out of the fog light body.
2. Replace the nut on the bottom of the wire guide, then reattach the passing lights body with the 2 allen-head
screws.
3. Reattach the 2 fog light wires removed previously (you can attach the wire you removed from the fork terminal
with or without reinstalling another fork terminal.).
4. Secure the fog light with the clamp ring.
5. Mount the new lighthead to its bracket as shown.
6. Extend the lighthead wires to your power source and connect as described in the lighthead manual.
Automotive:
Li
ghtheads
Installation Guide:
Model RBKTHD6 or 5BKT2 Mounting Bracket
Harley-Davidson® Passing / Fog Light Mount
®
ENGINEERING COMPANY INC.
Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: [email protected]
Customer Service e-mail: [email protected]
©2005 Whelen Engineering Company Inc.
Form No.13995A (060707)
Automot
ive:
Li
ghtheads
Installation Guide:
Model RBKTHD6 or 5BKT2 Mounting Bracket
Harley-Davidson® Passing / Fog Light Mount
®
ENGINEERING COMPANY INC.
Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: [email protected]
Customer Service e-mail: [email protected]
Installation:
1. Remove the clamp ring from the fog light and lift the fog light out. Unscrew both wire terminals, cut the fork
terminal off of the end of the GREY-BLACK wire and set the light aside.
2. Remove both allen-head screws from the passing light mounting bracket and unscrew the nut holding the wire
guide. Carefully lower the light and let it hang while you slide the grey fog light wire out of the bottom of the tube.
3. Remove the washer indicated and replace it with the lighthead mounting bracket.
Reassembly:
1. Thread the fog light wire up through the guide tube until it protruds out of the fog light body.
2. Replace the nut on the bottom of the wire guide, then reattach the passing lights body with the 2 allen-head
screws.
3. Reattach the 2 fog light wires removed previously (you can attach the wire you removed from the fork terminal
with or without reinstalling another fork terminal.).
4. Secure the fog light with the clamp ring.
5. Mount the new lighthead to its bracket as shown.
6. Extend the lighthead wires to your power source and connect as described in the lighthead manual.
©2005 Whelen Engineering Company Inc.
Form No.13995A (060707)
For warranty information regarding this product, visit www.whelen.com/warranty
For warranty information regarding this product, visit www.whelen.com/warranty