Whelen RBKTHD4L - Manual

Page 1
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
Fig. 1
U s e e x i s t i n g b o l t s
Automotive:
Li
ghtheads
Installation Guide:
TIR 3™ Super LED® Lighthead Bracket Model RBKTHD4
Under Radio Box, Harley-Davidson® w/State Police Package
®
ENGINEERING COMPANY INC.
Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: [email protected]
Customer Service e-mail: [email protected]
Installation:
This bracket will install under the radio box using the bolts
that hold the radio box to the rear deck.
1.
Remove the radio box and place the bracket onto the radio
box bolts (Figs 1 & 2).
2. Remount radio box, securing the lighthead bracket.
3. Mount the lighthead to the bracket using the supplied
flange and metal screws (Fig. 3).
4. Extend the lighthead wires to your power source and refer
to the lighthead manual for instructions.
IMPORTANT! It is the responsibility of the installation
technician to make sure that the installation and operation
of this product will not interfere with or compromise the
operation or efficiency of any vehicle equipment!
IMPORTANT! Before returning the vehicle to active service,
visually confirm the proper operation of this product, as
well as all vehicle components/equipment.
©2004 Whelen Engineering Company
Inc. Form No.13933C (030409)
For warranty information regarding this product, visit www.whelen.com/warranty
Fig. 2
Fig. 1
U s e e x i s t i n g b o l t s
Automot
ive:
Li
ghtheads
Installation Guide:
TIR 3™ Super LED® Lighthead Bracket Model RBKTHD4
Under Radio Box, Harley-Davidson® w/State Police Package
®
ENGINEERING COMPANY INC.
Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: [email protected]
Customer Service e-mail: [email protected]
Installation:
This bracket will install under the radio box using the bolts
that hold the radio box to the rear deck.
1.
Remove the radio box and place the bracket onto the radio
box bolts (Figs 1 & 2).
2. Remount radio box, securing the lighthead bracket.
3. Mount the lighthead to the bracket using the supplied
flange and metal screws (Fig. 3).
4. Extend the lighthead wires to your power source and refer
to the lighthead manual for instructions.
IMPORTANT! It is the responsibility of the installation
technician to make sure that the installation and operation
of this product will not interfere with or compromise the
operation or efficiency of any vehicle equipment!
IMPORTANT! Before returning the vehicle to active service,
visually confirm the proper operation of this product, as
well as all vehicle components/equipment.
©2004 Whelen Engineering Company
Inc. Form No.13933C (030409)
For warranty information regarding this product, visit www.whelen.com/warranty
Fig. 2