Whelen M9FCZ900 User Manual

Automotive: lightheads

Page 1

Round Hole

Grommets

Flange Gasket

Adaptor Plate

Grommet

M9 Flange

8 X 1 3/4" PPHSMS

(2 places)

8 X 1 PPHSMS

(4 places)

ENGINEERING COMPANY INC.

Automotive:

Lightheads

Installation Guide:

900 Series to M9 Series Scenelight

Adaptor Flange

For warranty information regarding this product, visit www.whelen.com/warranty

51 Winthrop Road
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: [email protected]
Customer Service e-mail: [email protected]

Installation:

1. Remove the existing 900 series lighthead and gasket

from the mounting surface.

2. Install the 2 square grommets into the Adaptor Plate

as shown.

3. Route the M9 lighthead wires through the wire

passage hole. Using the hardware provided secire the
M9 lighthead to the adaptor plate.

4. Install the 4, round hole screw grommets into the

exisiting mounting holes.

5. Position the adaptor plate/lighthead assembly onto the

flange gasket. Make sure that this assembly is
positioned so that the gasket fits properly.

6. Place this assembly into position on the mounting

surface. Now mount the M9 flange onto the flange
gasket and secure the complete assembly to the
mounting surface using the hardware shown.

7. Extend the lighthead wires to your power source and

connect as shown in the lighthead manual.