Whelen M7FC700 User Manual

Automotive: li ghtheads, Automot ive: li ghtheads

Page 1

Round Hole

Grommets

Mounting

Gasket

Flange

8 X 1 PPHSMS

Grommet

2.5"

7.5"

M7 Mounting Configuration

#8 X 1 PPHSMS

Automotive:

ghtheads

Installation Guide:

700 Series to M7 Series Flange Adapter

Model M7FC700

ENGINEERING COMPANY INC.

Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: [email protected]
Customer Service e-mail: [email protected]

For warranty information regarding this product, visit www.whelen.com/warranty

51 Winthrop Road,

Chester, Connecticut 06412-0684

Phone: (860) 526-9504

Fax: (860) 526-4078

Mounting:

1. Remove the existing 700 series lighthead and gasket from the mounting surface.

2. Mark the M7 flange mounting hole locations onto the

mounting surface by using the flange as a
template or using the measurements
shown.

3. Drill four 1/4 inch mounting

holes and insert the four
supplied #8 round hole
grommets.

4. Insert the two #8 square grommets into the

flange and secure the lighthead to the flange
with two #8 X 1” sheet metal screws.
NOTE: Due to the mounting hole locations
for the M Series and the variety of lighthead
styles which may be replaced, cutting or
drilling may be required for the screws
going into the square grommets.

5. Secure the Flange and lighthead to the vehicle

with the 4 supplied #8 X 1” sheet metal screws
and round grommets you installed in step 3.

6. Extend the wires to your power source and

connect as shown in the lighthead manual.