Whelen 1200DHAP - Manual (Page 5)

Page 5
BLACK WIRE, NEGATIVE (-)
RED WIRE, POSITIVE (+) ON/OFF SWITCH FUSE
WIRES TO POWER SOURCE
WIRES TO STROBE
LIGHT HEAD ASSEMBLY
DOUBLE POLE, DOUBLE THROW
CENTER OFF SWITCH (REAR VIEW)
BLACK WIRE, NEGATIVE (-)
RED WIRE, POSITIVE (+)
RED WIRE, POSITIVE (+)
BLACK WIRE, NEGATIVE (-)
VIOLET WIRE, NEGATIVE (-) HI/LOW
WIRES TO POWER SOURCE
WIRES TO STROBE
LIGHT HEAD ASSEMBLY
FUSE
GRAY WIRE, POSITIVE (+) CRUISE LIGHT, 12 OR 24 VDC
DOUBLE POLE, DOUBLE THROW
CENTER OFF SWITCH (REAR VIEW)
BLACK WIRE, NEG. (-)
RED WIRE, POS. (+) RED WIRE, POSITIVE (+)
BLACK WIRE, NEGATIVE (-)
VIOLET WIRE, NEGATIVE (-) HI/LOW
WIRES TO POWER SOURCE
WIRES TO STROBE
LIGHT HEAD ASSEMBLY
FUSE
GRAY WIRE, POSITIVE (+) CRUISE LIGHT, 12 OR 24 VDC 1 AMP FUSE
MODEL 1200D STANDARD.
ON/OFF SWITCHING
FOR HIGH POWER
ONLY.
MODEL 1200D STANDARD.
HIGH/OFF/LOW SWITCHING.
NOTE: Cut Violet (looped) wire, run
it out of unit with black and red wires.
When the violet wire is grounded,
you are in the high mode and
when the violet wire is floating
you are in the low mode.
IMPORTANT: Cruise light
is 12 VDC or 24 VDC bulb.
MODEL 1200D WITH CRUISE
LIGHT OPTION.
NOTE: Strobe light and cruise light
are connected to same DPDT
CENTER OFF switch control.
MODEL 1200D WITH CRUISE
LIGHT OPTION.
IMPORTANT: Cruise light
is 12 VDC or 24 VDC bulb.
NOTE: Strobe light is controlled by
DPDT CENTER OFF switch control,
and cruise light is controlled by
ON/OFF switch control.
NOTES: 5 AMP
3 AMP 24 VDC
ALL SWITCHES AND FUSES ARE CUSTOMER SUPPLIED. USE FUSE FOR 12 VDC
OPERATION, AND FUSE FOR OPERATION.
SWITCH CONTROL WIRING SCHEMATICS FOR THE 1200D STROBE LIGHT SERIES
+
+
BLACK WIRE, NEGATIVE (-)
RED WIRE, POSITIVE (+)
RED WIRE, POSITIVE (+)
BLACK WIRE, NEGATIVE (-)
VIOLET WIRE, NEGATIVE (-) HI/LOW
WIRES TO POWER SOURCE
WIRES TO STROBE
LIGHT HEAD ASSEMBLY
FUSE
DOUBLE POLE, DOUBLE THROW
CENTER OFF SWITCH (REAR VIEW)
+
+
Fig. 6