KEPCO RA 60 Rev 1, 2, 3 - Manual (Page 14)

2-2
RA60 SERIES 090910
2.3 TERMINATIONS
All input, output and control terminations are located on the rear panel of the rack adapter (see
Figure 2-2). Other than module keying (Para.2.2), no adjustments or alignments are required.
FIGURE 2-2. REAR PANEL CONNECTIONS
2.4 COOLING
The HSP power supplies mounted within the rack adapter are maintained within their operating
temperature range by means of internal cooling fans. ALL INLET AND EXHAUST OPENINGS
AROUND THE RACK ADAPTER CASE MUST BE KEPT CLEAR OF OBSTRUCTION TO
ENSURE PROPER AIR ENTRY AND EXHAUST. Care must be taken that the ambient temper-
ature, which is the temperature of the air immediately surrounding the rack adapter, does not
rise above the specified limits for the operating load conditions of the installed HSP power sup-
plies. Kepco recommends providing additional space above and below the rack adapter where
possible when the rack adapter is fully populated.
2.5 INSTALLATION (Refer to “Mechanical Outline Drawing,” Figure 1-2.
RA 60 Series rack adapters are designed for rack-mounted applications. The rack adapter will
mount directly to EIA standard 19" racks; optional mounting ears are available to provide for