KEPCO KLP Series Quick Start Guide, P/N 228-1616, Rev 2 - Manual (Page 2)

2
228-1616 REV 2 102607
KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11355 U.S.A. " TEL (718) 461-7000 " FAX (718) 767-1102
http://www.kepcopower.com " email: [email protected]
DESCRIPTION. The KLP Power Supply Series are universal input, automatic crossover, 1200-watt
constant power, voltage/current stabilizers with a full rectangular output characteristic. There are six KLP
-1200 Models and six KLP -1.2K Models (see Table 1). The KLP -1200 Models are GPIB and RS 232
compatible; the -1.2K Models are GPIB and LAN compatible; all models allow remote analog program-
ming. For each model a multitude of virtual models can be configured. The “rated voltage, maximum cur-
rent at rated voltage” and “rated current and maximum voltage at rated current” parameters define the
virtual models available within the limit of 1200 Watts of output power.
UNPACKING. This instrument has been thoroughly inspected and tested prior to packing and is
ready for operation. After careful unpacking, inspect for shipping damage before attempting to operate.
Perform the PRELIMINARY OPERATIONAL CHECK. If any indication of damage is found, file an imme-
diate claim with the responsible transport service.
EQUIPMENT SUPPLIED . See Table 2.
TABLE 1. MODEL PARAMETERS
Model number
Rated
Voltage
Range
(1)
Maximum
current for
rated voltage
Minimum
programmable
current
Rated
Current
Range
(1)
Maximum
voltage for
rated current
Ripple
and
noise
p-p
(2)
Efficiency
@115 Va-c
KLP 10-150-
(3)
0-10V 120A@10V 3.2A 0-150A 8V@150A 75 mV 80%
KLP 20-120-
(3)
0-20V 60A@20V 1.6A 0-120A 10V@120A 75 mV 82%
KLP 36-60-
(3)
0-36V 33.3A@36V 0.8A 0-60A 20V@60A 125 mV 83%
KLP 75-33-
(3)
0-75V 16A@75V 0.4A 0-33.3A [email protected] 125 mV 84%
KLP 150-16-
(3)
0-150V 8A@150V 0.2A 0-16A 75V@16A 125 mV 86%
KLP 300-8-
(3)
0-300V 4A@300V 0.1A 0-8A 150V@8A 300 mV 87%
KLP 600-4-
(3)
0-600V 2A@600V 0.05A 0-4A 300V@4A 400 mV 88%
(1) The maximum current and voltage are constrained by the 1200 watt power limitation.
(2) Bandwidth: 20MHz; low frequency ripple may be higher at loads less than 30 Watts.
(3) Specifications listed apply to both -1200 and -1.2K Models.
TABLE 2. EQUIPMENT SUPPLIED
ITEM PART NUMBER QUANTITY
Source power connector 142-0381 1
Jumper (28 AWG or larger bus wire) for local sensing connections 172-0298 2
Analog I/O port mating connector 142-0528 1
Documentation CD (includes Documentation and Drivers) 254-0034 1