TA Triumph-Adler DC 2018 - Manual (Page 67)

OPERATION GUIDE 6-1
6 Troubleshooting
General Guidelines
The table below provides basic solutions for problems you may encounter with the
machine. We suggest you consult this table to troubleshoot the problems before
calling for service.
Symptom Check Item Corrective Action Reference
Nothing lights on the
operation panel when
the power switch is
turned on. Is the power plug connected to
an AC outlet? Connect the plug to an AC
outlet. —
No copies delivered
after Start is
pressed. Is there some indication of the
trouble on the operation panel? Check the appropriate
response to that indication and
perform the corresponding
procedure. page 6-3
Blank copies. Were the originals placed
correctly? When placing originals on the
platen, place them face-down. page 4-1
When setting originals in the
optional document processor,
place them face-up. —
Light copies. Is the copier in the Auto
Exposure Adjustment mode? Perform the Auto Exposure
Adjustment procedure. —
Is the copier in either the
Photo, Text+Photo, or Text
mode? Adjust the exposure to the
correct level. page 4-1
Is the copier in the Draft
mode? Select an image quality mode
other than the Draft mode. —
Is the Add Toner indicator lit? Replace the toner container. page 5-1
Is the copy paper damp? Replace the copy paper with
new paper. page 2-1
Dark copies. Is the copier in the Auto
Exposure Adjustment mode? Perform the Auto Exposure
Adjustment procedure. —
Is the copier in either the
Photo, Text +Photo, or Text
mode? Adjust the exposure to the
correct level. page 4-1
Dirty copies. Is the platen or the optional
document processor dirty? Clean the platen and/or the
optional document processor. page 5-1
Clean the charger. page 5-4
2GM_UTAX_ENG_OG.book 1 ページ ２００５年３月４日 金曜日 午後９時４５分