EZQuest DVD Duplication - Manual (Page 48)

6.4 About Buttons
If you press any one of the four buttons on the panel, but there is no response, it is
perhaps that the button cannot function well. Please inspect the jumper setting.
6.5 About DVD Writer Not Readable
After copying if the DVD writer is not readable, please use Compare to examine, or
get another DVD-ROM to test.
6.6 About High Failure Rate
If the failure rate of copying is high, please do the following things to improve.
l Lower the speed of DVD writer
l Inspect if the blank diskís quality is bad.
l Update the firmware.
l Inspect the DVD writerís maximum writing speed. If the speed is over 24X,
copy the data to a hard disk first, and then transmit to DVD.
6.7 About Firmware Update
If you cannot update the firmware, please inspect the BIOS program. Perhaps you
have downloaded a wrong program, or let a zipped file be written into DVD. The
zipped file should be unzipped first.
Failure in firmware update may cause the copy smart plus to fail in booting. Under
the circumstances, please return the control board to ACARD for repair.
Page 48