SAF OPAL SS6 - Manual (Page 20)

OPAL SS6 Reduced Voltage Starters
Page 13
3.2 ANNUNCIATION
3.2.1 LED INDICATIONS
LED NAME COLOUR DESCRIPTION
LD1
OVER
TEMP
RED
On when unit is faulted because of an open Over
Temperature switch at the OT terminal
LD2 READY GREEN This LED is illuminated when there are no faults
LD3 RUN GREEN Indication of run commanded to starter
LD4
MOTOR
OVRLD
RED
When lit an IOC (instantaneous over-current) or
an inverse time overload fault exists
LD5 +15V GREEN Illuminated when +15V power supply is okay
3.2.2 NEON INDICATIONS
NEON NAME DESCRIPTION
NE1 SCR 1,2
Should be lit during stop and extinguished when the motor is
up to speed. This represents the status of SCR 1 and 2
NE2 L1 ON
Indicates voltage is present on L1
NE3 SCR 3,4
Should be lit during stop and extinguished when the motor is
up to speed. This represents the status of SCR 3 and 4
NE4 L2 ON
Indicates voltage is present on L2
NE5 SCR 5,6
Should be lit during stop and extinguished when the motor is
up to speed. This represents the status of SCR 5 and 6
NE6 L3 ON Indicates voltage is present on L3
3.3 ADJUSTMENTS
3.3.1 POTENTIOMETERS
POT NAME RANGE
DEFAULT
SETTING
DESCRIPTION
RV1 RATE 2-3 SEC 50%
Adjusts the time of the current ramping
CW rotation decreases the time
RV2 STEP 150-350% 50%
Adjusts the starting current or breakaway
torque
CW increases the torque (current)