Rugged Cams Fusion DVR - Manual (Page 39)

4CH User Guide
2-3. PTZ operation
To operate the PTZ functions, connect the controller to the RS-485 port on the rear
panel.
In the PTZ control setting in the setup menu, user can select or set the protocol type of
the camera which is the same as the one that is installed on the site. If the camera has
a specific camera ID, select the camera ID using Left or Right button.
The PTZ function button is found on the front panel. Once you press the PTZ button,
the screen will appear as in figure 4.3.1. Highlight the item to select and control the
cameras by using the UP and DOWN or LEFT and RIGHT buttons. Please refer to the
table 4.3.1. for description.
39
[Picture 2-3] Figure 4.3.1. PTZF control screen
Initialize the PTZ settings of the selected camera. INTIALIZE
Use the UP or DOWN button for ZOOM in or out and LEFT or RIGHT button for
FOCUS near or far of the selected camera.
ZOOM / FOCUS
Use the UP or DOWN button for TILT and LEFT or RIGHT button for PAN of
the selected camera.
PAN / TILT
Description Button
[Table 2-3] Button functions in PTZF control