Rosen Aviation 19-55 : Remote electronics - Manual (Page 30)

Rosen Aviation Remote Display System
Document Number: 105478 Revision: F
Date: 06/23/14
Template: 4.4.1.6FM2; Revision A; 12/06/12 Page 30 of 38
10.6.2. Constant Mode
Constant enables you to specify the two sources the monitor will switch between when
the constant switch goes between an open state and a ground state.
Highlight TechnicianSource ModeSource Select and press ENTER.
Select Constant and press ENTER. Press ▼ to select Open and press ENTER.
Select which video input will be set to open and press ENTER.
Press ▼ to select Ground and press ENTER.
Select which video input will be set to ground and press ENTER.
Select Back and press ENTER to return to the Technician Menu.
Press EXIT to exit the OSD.
Figure 28 Source Select Constant options