RIGOL DG1000Z Series - Manual (Page 64)

RIGOL
20 DG1000Z Quick Guide
6. To set harmonic amplitude
Press Harmonic Ampl in the harmonic setting menu to set the amplitude of the
2 nd and 4 th harmonics.
1) Press SN, use the numeric keyboard to input 2 and press Sure.
2) Press Harmonic Ampl, use the numeric keyboard to input 2 and select
Vpp from the pop-up menu.
3) Set the amplitude of the 4 th harmonic to 1Vpp according to 1) and 2).
7. To set harmonic phase
Press Harmonic Phase in the harmonic setting menu to set the phase of the
2 nd and 4 th harmonics.
1) Press SN, use the numeric keyboard to input 2 and press Sure.
2) Press Harmonic Phase, use the numeric keyboard to input 30 and select °
from the pop-up menu.
3) Set the phase of the 4 th harmonic to 50° according to 1) and 2).
9. To enable the output
Press Output1 to turn CH1 output on. At this point, the backlight goes on and
the [CH1] connector outputs the fundamental waveform as well as the 2
nd and
4 th harmonics.
10. To observe the output waveform
Connect the [CH1] connector to the oscilloscope using BNC cable. The
waveform is as shown in Figure 9.
Figure 8 Harmonics