RIGOL DG1000Z Series - Manual (Page 48)

RIGOL
4 DG1000Z Quick Guide
Front Panel Overview
16 15 14 13 12 11 10
1 2 3 4 5 6 7 8 9
Figure 1 Front Panel
1. Power Key
The power key is used to turn the generator on or off.
2. USB Host
The USB Host interface is used to be connected an USB storage device to read
the saved waveform or state files or store the current instrument state and
edited waveform data into the USB storage device. In additional, the content
displayed in the screen is also can be saved as a picture file (*.Bmp) in the USB
storage device.
3. Page Down
This key is used to open the next page of the current menu.
4. Return to the Previous Menu
Quit the current menu and return to the previous menu.
5. CH1 Output Connector
BNC connector. The nominal output impedance is 50Ω.
When the Output1 is enabled (the backlight goes on), this connector outputs
the waveform based on the current settings of CH1.
6. CH2 Output Connector
BNC connector. The nominal output impedance is 50Ω.
When the Output2 is enabled (the backlight goes on), this connector outputs
the waveform based on the current settings of CH2.