RIGOL MSO/DS2000A Series - Manual (Page 60)

RIGOL
MSO2000A/DS2000A Quick Guide 10
(1) Turn off the instrument and remove the power cord.
(2) Insert a small straight screwdriver into the slot at the power socket and pry
out the fuse seat gently.
(3) Take out the fuse and replace it with a fuse of the specified specification.
Then, reinstall the fuse seat.
5． AC Power Socket
AC power input terminal. The power requirement of this oscilloscope is 100-240
V, 45-440 Hz. Use the power cord provided with the accessories to connect the
instrument to AC power. Then, you can press the power key at the front panel to
start the instrument.
6． Lock Hole
You can lock the instrument to a fixed location using the security lock (please
buy it yourself) via the lock hole.
7． Trigger Out
The oscilloscope can output a signal that can reflect the current capture rate of
the oscilloscope at each trigger via this interface. Connect the signal to a
waveform display device and measure the frequency of the signal. The
measurement result is the same with the current capture rate. The instrument
can also output a signal when failed waveform is detected during the pass/fail
test.
8． Source Output
When Source1 or Source2 is enabled, the signal currently set can be output
through the [Source1] or [Source2] connector at the rear panel to the analog
input terminal of the oscilloscope or external devices connected to them. This
function is only available for MSO2000A-S and DS2000A-S models oscilloscopes.