Extron electronic MTP U R RS SEQ - Manual (Page 16)

MTP U R Series • Installation
Installation, cont’d
12
1 . Remove the feet from the bottom of the MTP, if they are
installed.
2 . Attach the mounting brackets to the MTP with the machine
screws provided.
3 . For furniture mounting , hold the MTP with the attached
brackets against the mounting surface. Mark the bracket
screw hole locations on the mounting surface.
4 . For furniture mounting , drill 3/32" (2 mm) diameter pilot
holes, 1/4" (6.3 mm) deep in the mounting surface at the
marked screw locations.
5 . For furniture mounting , insert #8 wood screws into the four
pilot holes. Tighten each screw into the mounting surface
until just less than 1/4" (6 mm) of the screw head protrudes.
6 . For furniture mounting , align the mounting screws with
the slots in the brackets and place the MTP against the
surface, with the screws through the bracket slots.
7 . For furniture mounting , slide the MTP slightly forward or
back, then tighten all four screws to secure the MTP in place.
8 . For projector mounting , secure the MTP to a projector
mount by inserting the mounting bolt through the
bracket’s slotted hole.