Epson 500 - Manual (Page 21)

21
Basic Operation
Make sure the projector is set up as described on page 13, then follow the instructions below
to turn it on and display an image.
Turning On the Projector
1. Remove the lens cap.
2. Press the On button on the remote control, or press the
Power button on the projector.
Note: If this is your first time using the remote control,
make sure batteries are installed as described on page 55.
To keep children from turning on the projector, you can use
the projector’s Operation Lock (see page 25).
The projector takes about 30 seconds to warm up and
display an image. If you don’t see a picture, you may
need to change the image source as described on the
next page.
Turn on the projector