Inverting and mirroring the image, Selecting the input signal setting – Epson 500 User Manual
Page 19

Displaying and Adjusting the Image
19
Inverting and Mirroring the Image
If the image is displayed upside-down or backward, select the correct Projection option:
1. Press the
Menu
button on the remote control.
2. Use the menu navigation buttons to open the
Setting
menu, then open the
Screen
menu, and then select
Projection
.
3. Choose from these options:
■
Front
if the projector is located in front of the
screen (for example, on a table).
■
Front/Ceiling
if the projector is located in front
of the screen and mounted overhead.
■
Rear
if the projector is located behind the screen.
■
Rear/Ceiling
if the projector is located behind
the screen and mounted overhead.
Selecting the Input Signal Setting
If you’re using the projector’s Input A or Input B port, select the correct setting for the type of
equipment you’ve connected to it:
1. Press the
Menu
button on the remote control.
2. Use the menu navigation buttons to open the
Setting
menu, then open the
Input Signal
menu, and then select
Input A
or
Input B
(depending on the port to which you’ve
connected the equipment).
3. Choose from these options:
■
YCbCr
if your video player outputs an NTSC signal.
■
YPbPr
if your video player outputs an HDTV signal.
■
RGB-Video
if your video player outputs an RGB video signal.
■
RGB
if the image is coming from a computer.
Note: If you’re unsure which setting to use, check the label next to the port on your video
equipment.
Menu
button
Menu
navigation
buttons