Precision Digital PD6820 - Manual (Page 31)

PD6820 Loop-Powered Process Meter Instruction Manual
31
Manual or Automatic Total Reset Function (t rST)
The meter may be programmed to reset the total either manually using the Reset
button or automatically. Manual reset button may be disabled to avoid inadvertent
total reset.
The automatic reset is based on the set point programmed in the Advanced menu:
OUTPUT
 alrm  total. Once the set point is reached, the meter waits for a
programmed amount of time (t dly) and then resets the total to zero.

To enable total reset by Reset button, choose man  Enabl.
 To disable total reset by Reset button, choose man  dsabl.
 To reset total upon total alarm set point, choose auto, enter a time delay
(t dly), and proceed to programming the set point, see page 38.
Press the Enter button, at any time, to accept a setting or Menu button to exit without
saving changes.
t rst
SeTUP
nman
T RESET
Auto
T RESET
Enter Reset Delay
(seconds)
0 0010
T DELAY
enabl
MAN RST
DSABL
MAN RST